, , , , , ,

Fireye UV1A12 Flame Scanner

$713.00

Fireye UV1A12 flame scanner, ultraviolet miniature non self-check, suitable for fuel gases and no. 2 oil. UV1A6 comes in 1/2″ NPT connector.

Availability: 5 in stock

Fireye UV1A12 Flame Scanner is used with the M-Series, M-Series II, and MicroM controls as well as the Fireye FLAME-MONITOR, BurnerLogix and Nexus System. The UV1A12 scanner comes with 12 ft. cable rated for Tray Cable – Exposed Run (TC-ER). It complies with the crush and impact requirements of the standard for metal-clad cable, UL 1569.

The UV tube is made of quartz and is filled with a gas that ionizes when struck by UV radiation from the flame. In the absence of UV radiation, the gas acts as an insulator between two electrodes that are mounted inside the tube. These electrodes are energized continuously by a high voltage. During combustion, UV radiation ionizes the gas, causing current pulses to flow between the electrodes. These current pulses result in a flame signal which is transmitted to the amplifier in the control, where it is processed to energize or hold in the flame relay.

Fireye UV1A12 flame scanner is recommended for detecting flames from standard fuel gases, some waste gases and light oil fuels such as No. 2 oil. Flames from heavier oils can be detected with UV scanners but the unburned fuel shroud and/or atomization shroud can block the passage of the UV from the flame zone to the UV tube, causing nuisance burner/boiler trips. Infrared detection is recommended for fuel oil heavier than No. 2, and some installations where waste gases are burned together with natural gas as the main flame.

 

Documents

Product Datasheet / Manual / Installation Instruction documents are provided below:

Manual

 

Reviews

There are no reviews yet.

Be the first to review “Fireye UV1A12 Flame Scanner”

Your email address will not be published. Required fields are marked *

Weight 1.75 lbs
Dimensions 9.5 × 6.5 × 4 in
Shopping Cart